MSRP: $150.00 USD | Product # 8000137 |
Buy Online
For raised or flush-mounted side rails with an interior track, this dual-claw tower design is a match made in heaven.
MSRP: $150.00 USD | Product # 8000137 |
Buy Online
For raised or flush-mounted side rails with an interior track, this dual-claw tower design is a match made in heaven.
Q: What else is needed to complete a basic rack set up?
A: Just crossbars and lock cores. Check the Fit List to find the correct length crossbar. Locks are not required, but a really good idea.
Q: Is there a way I can make the towers taller?
A: There is no way to make the towers taller.
Q: What sort of maintenance should I perform?
A: Performing maintenance is always a good idea to protect your car and make your rack system last longer. Lubricate nuts, screws, or bolts with grease. Lubricate locks with graphite. Remove the rack when not in use, or at least periodically to clean the pads and the vehicles roof. Clean the rack periodically, especially in marine environments and where road salt is used.
Q: How do I know if the towers are installed correctly?
A: Check the safety steps in the LowRider instructions. These guidelines will help you determine if the installation is correct.
Q: Will the rack make a lot of noise?
A: Maybe. Wind noise is hard to predict, but it is more often an issue when the rack has little or no load. We make two products, the Fairing and Windjammer, to help control this situation. Large loads tend to dampen noise also. If you have a sunroof the fairing is a good way to help control air flow.
Q: Will it damage my car?
A: We take fitting cars very seriously, and do everything we can to minimize any effect our rack may have on your cars. However, anything coming into contact with a car’s finish, our racks included, will have some effect over time, and some cars are more prone to these issues than others. So where the possibility of such issues is predictable, we make note of that in the Fit List. When the rack will not be in use for an extended period, it is a good idea to take the rack off of the car. You can also do a lot for yourself by: (1) Making sure the car is clean and well waxed prior to installing the rack, (2) Following all instructions for installation and usage, and (3) avoiding situations, like car washes, where the rack may be impacted.
Q: Do I need any Tools to install the towers?
A: Nope.
Q: The towers contact my factory crossbars. Is that okay?
A. No. If any part of an accessory or tower contacts the factory-installed crossbars, and if the factory bars cannot be moved out of the way, remove them completely.
Q: Where can I get more of the clear tape on the claw?
A. The clear tape is often referred to as "Rhino Hide" or "ski tape" and can be purchased in auto supply stores or outdoor retailers.
Q. One tower is installed fine, but the other one keeps popping off the bar. What's wrong?
A. Be sure to pull the towers towards you while tightening the adjustment screw.
MSRP: $150.00 USD
Product#: 8000137
Locking tower that fits to some factory racks. Fits some raised and flush-mounted side rails with an interior track.
Produced: 2006 to present
History: Upgrade from the non-locking EZ Rider.
General Information:
Height: 5-1/2” from top of crossbar to bottom of tower.
Capacity: Varies by application, check Fit List.
